Super VXO

Ok, so mostly I am a DDS and Arduino kind of guy, they just work, they don’t drift and they are super simple. But sometimes, you get that “Retro” kind of nostalgia happening and a desire to build something rock bound. I have a ton of crystals in matched pairs for 7mhz, enough to cover the whole CW portion to 7.050. So i thought, what the hell, I will make a Super VXO, and incorporate it into a transceiver if it proves to be stable enough.

15780B3E4DDA4EBB16D9DA
So i went looking for a suitable circuit to modify to suit my parts bin and needs. And i came across this one above. Varactor tuning is nice, as getting quality air variable caps and reduction drives is impossible, so varactors are must. The only thing i changed is the inductor as I do not have any Toko IF coils, and the only other thing i changed was to add an unbalanced to balanced transformer to split the signal in to, one for the receiver and the other for the transmitter. The original article and assocciated info for this Super VXO can be foundĀ HERE!!

vxo-board

Laid the board out in Sprint Layout, and after ironing out the bugs with the help of Ben VK6FBLJ who put his eyes over the layout and noticed all the errors, the gerbers were then converted to gcode for routing.

IMG_20160402_192238

Could fit 2 boards on the one sheet of FR4 the above picture is the boards on the mill deck still after routing and v-cutting in two.

IMG_20160402_205338

And this is the finished board after being cleaned with steel wool and a coat of PCB lacquer being applied. They have come up rather nice looking. More to come on this, after they have been built and tested to see how stable they are.

UPDATE 1:
IMG_20160403_094931

Most of the parts are installed, I threw in a pair of 10mhz xtals for testing with, they will not be the what is used in the final board, but are good enough for testing purposes. Just have the inductors to wind, 10 turn pot to wire up and the 8v regulator to install and it is ready for smoke test. Oh and i was able to find a MV2109 varactor in my semi conductor box, so, no cheeping out and using a silicon rectifier.

UPDATE 2:

Well i cannot get this thing to start oscillating. Have tried just about everything i can think of, will post back when i work out what the case is.

Facebooktwittergoogle_plusredditpinterestlinkedin

Leave a Reply

Your email address will not be published. Required fields are marked *