Going Over To The Dark Side

Well its bound to happen eventually, the need to use SMD components. I have been collecting some now for a while and ammassed a tidy little assortment of these beasts. Best of all, they will all fit into 3 tiny ring binders. One for Caps, one for Resistors and one for Inductors and Semi Conductors. Might as well get in now and make a collection before all the large sized SMD vanish and only the grains of sand remain. I currently only have the one binder, but have 2 more on the way from China just to be sure to be sure.

Facebooktwittergoogle_plusredditpinterestlinkedin

M4070 LCR Meter

I have not had much luck with the inductance setting on LCR meters. Most of them are crap, inaccurate and just plane useless. I think this is the 5th cheapish meter I have tried and I have finally hit on one that works and works well. In the picture below is a 1.8uH slug tuned variable inductor. So yes, it works and is accurate and with 3 decimal places its going to be nice to use for getting those hand wound toriod inductors right. The test frequency is a bit low, it would be nice if it was in the MHZ range rather than KHZ, but for that you need to spend up big on high end gear, not $70 on ebay.

Facebooktwittergoogle_plusredditpinterestlinkedin