MPSH10 IF AMP

So i had another swing at the MPSH10 in LT Spice and what it says should happen and what actually is happening are 2 very different things. I got it sorted and it is working fine. But I am not sure if i run with this or revert back to the 2n3904. For now I will run with this and see how it goes, I just have to measure the input and output impedances. Which as of next week or so, will be easier when i have a vna. The circuit is a little different to what was in the schematic in the previous post. I will update the schematic if I end up running with these.

I build this a little different, I had these squares sitting there i made so I used them.

Oscilloscope output, green trace is the signal in, yellow signal out.

 

Output from the spectrum analyzer.

Facebooktwittergoogle_plusredditpinterestlinkedin

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.